Control application

The main control application of Aquarium control implements the following features:

• Data acquisition of water temperature, pH and conductivity
• Data acquisition of ambient temperature and humidity
• Fresh water refill control
• Feed control
• Water temperature control using air ventilation and heater
• Calculation of refill tank content based on water level measurement
• Actuation of pump for water exchange

Additionally, the main control application implements the following supporting features:

• HW-Tests
• Text-To-Speech interface
• Logging
• Command interface to receive instructions from outside of the application
• Storage of recorded data in SQL database
• File-based communication to web application
• Monitoring and repair of relay board state

The control application makes extensive use of the pigpio library.

The architecture of the application uses various threads.

The application is automatic start by using systemd.

Installation

Enable I2C on Raspberry Pi

See detailed instructions how to use rasp-config.

Create a file for the message queue

The file is automatically created when running make install.

Alternatively, run the command sudo touch /var/local/aquarium-ctrl.mq.

The file is defined in the source file UsrIntrfc/MsgQu.h.

Create a ramdisk

Create the folder /mnt/ramdisk.

Add the following line to /etc/fstab: tmpfs /mnt/ramdisk tmpfs nodev,nosuid,size=50M 0 0.

Add a symbolic link using the command ln -s /mnt/ramdisk /var/local/aquarium-ctrl.

Automatic start of control application

[instructions for configuring automatic start of control application.]

Create the website

In the folder /var/www/html, create the website using git clone https://in-dubio@bitbucket.org/in-dubio/aquarium-web.git.

Change the owner of the website to user pi and change the group of the website to www-data.

Create a symbolic link to the log file running ln -s /var/log/aquarium-ctrl-session.log /var/www/html/aquarium-web/logfile.txt.

Create the file /var/www/app.ini with the following content (set the correct password): [database] server = localhost port = 3306 user = aquarium password = YourPassword database = aquarium

Setup of database

• Import an empty database.
• Create the user aquarium and assign access rights to the aquarium database.